The base is necessarily prepared before the installation of a related system of thermal insulation is started. Using the insulating solutions, the alignment of defects is performed, for example, with a bias in a vertical direction of more than 20 mm – per meter of the surface.
Когда крепится материал для теплоизоляции к поверхности стены дома используется минеральный состав клея со свойствами отталкивания влаги. Avoid the appearance of cold bridges is possible when using steel dowels for fastening for the facade with heat -compensators.
First of all, at a basement level, aluminum rails are placed, on which there are a number of material for thermal insulation from below. Apply dressing when installing all the following layers. In order to remove moisture, you need to equip enhancing profiles above window and doorways with special droppers.
Performing work on the main as well as a protective decorative layers are done when the installation of the thermal insulation system is completed.
On top of the insulation, an adhesive mineral solution is applied first. During the application of the base, a fiberglass alkaline resistant mesh is used. It must be deepened into the glue solution. The grid gives the protection of the reinforcing layer and at the same time enhances it.
The corners of plastic and the grid are used for angular strengthening in the structure with slopes in door and window openings. A tape for sealing with a special sealant will be needed to glue the heat insulator to the windows with doors. And on the surface with plaster, it is better to glue thermal insulation to the mineral adhesive composition.
Of course, in the joints of the facade with the roof, the possibility of increasing humidity is high. This means that the introduction of a layer of waterproofing in the plaster is very necessary.
For proper adhesion, it is worth treating the facade with a primer with a quartz filler, and after that apply the last layer. How the last layer uses a variety of varieties of decorative plasters. This plaster is made specifically for decorative and protective houses for facades. If you want, you can add non -burning pigments to the plaster, which can retain shades for more than 15 years. This is how acrylic, silicone or silicate compositions are done. Mineral plasters for decorations need to be stained in the future. For such, special paints with the effect of moisture repulsion, with a high degree of air and vapor permeability are selected.